top of page

Vent drive hardware – rack & pinion etc

Vent drive mechanisms

Taylor Built by Redpath  buildings use the quality range of “Dutch” Ridder brand rack and pinion vent drive arms. These very well proven racks are built to last and last and require little maintenance other than occasional greasing.  Redpath also supply the vent tube support bearing “tube bearings” which when fastened to the buildings rafter will both guide and support the vent drive tubes.

Use the form below to make an enquiry 

Note: Roof vent torque tube 5.85m length (includes 100mm swagged)

rack & pinion ridder by Redpath
Rack & Pinion

Straight Steel 1.450m complete


rack & pinion by Redpath
Swaged vent torque tube

25nb x 2.6mm x 5.85m


torque tube bearing venttbwl by Redpath
Vent Torque Tube Bearing

1″ Nylon & steel ball bearing

  • L $14.40 or Flat $12.00 

Grease 450 - b by Redpath
Vent Grease 450gram Cartridge

Food grade Super Red


Taylor Built by Redpath Greenhouses
bottom of page