Lockstrip Film Clipping Systems
Lockstrip film clipping system:
The original Taylor Built by Redpath clipping system has been used in the industry for nearly 40 years throughout Australasia.
Lockstrip is made up of three parts:
(1) The aluminium base is available in single-groove or twin-groove versions at 4.5m lengths.
(2) The insert strip 1.5m length is available in In long leg for up to 350 micron claddings ,and shortleg for over 350 microns
(3) Lockstrip clips – are small L shaped clip placed every 150mm along the system to secure the insert
You can purchase all parts separately by using the drop down arrow below.
Lockstrip is a slightly more complex and expensive clip system to use compared to the new type Duralock2 ( see above).
Lockstrip is a “self-locking” design that tightens as the wind load on the cladding increases.
Single longleg complete 3 piece for up to 350 micron
4.5m length $29.85
Single shortleg complete 3 piece for over 350 micron
4.5m length $29.85
Twin longleg complete 3 piece for up to 350 micron
4.5m length $48.98
Twin shortleg complete 3 piece for over 350 micron
4.5m length $48.98
Longleg insert & clips up to 350 micron
1.5m length $3.05
Shortleg insert & clips over 350 micron
1.5m length $3.05
Single base only
4.5m length $20.37
Twin base only
4.5m length $29.32
Longleg insert only
1.5m length $2.75
Shortleg insert only
1.5m length $2.75
Clips only
-
each $ 0.07
-
Bag of 100 $6.43
-
Bag of 1000 $ 59.50
Timber or Steel tek Screws Bags of 100
-
16mm 10g Steel $8.63
-
25mm 10g Steel $12.08 Timber $22.89
-
35mm 12g Steel $36.00 Timber $32.00
-
45mm 12g Steel $37.67 Timber $39.93
-
65mm 12g Steel $62.00 Timber $54.28
